as received:
- OS 3ch propo & Digit Migit b.jpg (31.79 KiB) Viewed 1602 times
An early OS 3 channel analogue TX converted to 2.4ghz
-
ozrs
- Posts: 114
- Joined: 16 Feb 2018, 15:21
- Location: West Australia
An early OS 3 channel analogue TX converted to 2.4ghz
Some pics of my converted OS set. Most were posted on previous forum, but original description has been lost - so just some brief comments (from memory).
as received: converted to 2.4 - changed to mode 1 so the left stick is now centering and the right stick is ratcheted for throttle: original internals: converted internals - uses a Futaba encoder from an 'Attack 4' (conversion predates availability of Phil's encoder) and a Frsky module: stick unit - I think I swapped out the simple springs on this: ball joint - in these stick units, the casing is often cracked, so it needed to be wrapped in heavy duty thread and epoxied: Also found this pic of a NIB example:
as received: converted to 2.4 - changed to mode 1 so the left stick is now centering and the right stick is ratcheted for throttle: original internals: converted internals - uses a Futaba encoder from an 'Attack 4' (conversion predates availability of Phil's encoder) and a Frsky module: stick unit - I think I swapped out the simple springs on this: ball joint - in these stick units, the casing is often cracked, so it needed to be wrapped in heavy duty thread and epoxied: Also found this pic of a NIB example:
Last edited by ozrs on 26 Feb 2018, 03:38, edited 5 times in total.
Richard
-
ozrs
- Posts: 114
- Joined: 16 Feb 2018, 15:21
- Location: West Australia
Re: An early OS 3 channel analogue TX converted to 2.4ghz
The set was also available in 'beige':
Richard