Page 1 of 1
Kraft Comander
Posted: 29 Dec 2020, 07:23
by JanW
I have a FrSky module, received from a friend I want to build in my Kraft Commander single channel now I have programmed an Aduino, who can help me with the connection data of the FrSky V8FT, I am looking for the pins for power and PPM signal.
Re: Kraft Comander
Posted: 29 Dec 2020, 13:18
by Ginger
Hi Jan, welcome to the forum, all the info you need is here:
viewtopic.php?f=62&t=91
Cheers
G
Re: Kraft Comander
Posted: 15 Jan 2021, 19:51
by MJF
JanW Try posting your question in the Help section under the Welcome banner.
I know less than nothing about Arduino, but would be surprised if the pin out was the same as Futaba. The Futaba pin info out was VERY useful to me for an upcoming project however!
Good luck with your Kraft Commander upgrade. I have an earlier ACE Commander conversion I have been using for a few years.
Mike F